316/316 Solid Fuel Stainless Steel Flue Liner Kit with Terracotta Pot Hanger. A double skinned flexible flue liner suitable for relining within a masonry chimney. Flue liner is suitable for use with burning gas, oil, coal, coke, cured dry logs, cured dry peat.
If the appliance is mainly going to be used to burn wood, and the appliance is not DEFRA approved you should increase the diameter of the Flue Liner to 150mm (providing this will fit in the masonry chimney), as recommended by Building Regulations. Whats Included in The Kit. Flue Liner per meter is approved and listed by HETAS EN1856-2 T450 N1 D V 3 L50012 G Nose cone ID Plate Terracotta Pot Hanger Equal Vitreous to Flue Liner Adaptor. Flue Liner is approved and listed by HETAS EN1856-2 T450 N1 D V 3 L50012 G. Wood, Oil, Gas, Low Sulpher Coal.
The flue liner has a smooth inner liner made from 316L grade stainless steel and is 0.12mm thick. The flue liner has a convoluted outer skin made from 316L stainless steel and is 0.12mm thick. The Flue Liner is constructed from a single strip of steel which is bent at 180 degrees and then the seam is folded in four planes to give a quattrolock seal.
Make sure the liner will go down the chimney (this can be done by pulling down a small section of the diameter liner you will be using) Sweep your chimney. Check you pot is in good condition, if you are NOT using a suspended cowl then remove the pot from the stack.
Flue Liner should always be fitted from the top. Make sure the arrows are pointing upwards (gas flow). Secure a piece of string at least the same length as the Flue Liner to the Nose Cone (order separately). Now attach the Nose Cone onto the end of the Flue Liner, again making sure the arrows on the Flue Liner are pointing away from the Nose Cone in a upward direction so when the liner is installed the arrows will be pointing to the top of the chimney Pull the liner down the chimney using the string and at the same time have someone at the top of the chimney feeding the Flue Liner down, once the Flue Liner is fitted remove the Nose Cone.
It is recommended that chimneys serving solid fuel appliances be swept and maintained as frequently as necessary but at least once a year. The item "Stove Flue Liner Pack 316 Grade Flue Liner Kit For Installation Of Stoves" is in sale since Thursday, May 18, 2017. This item is in the category "Home, Furniture & DIY\Fireplaces & Accessories\Heating Stoves".
The seller is "flue2u" and is located in Birchington, Kent. This item can be shipped to United Kingdom.